Chloramine T

Chloramine T

Treats: External bacterial and parasitic infections.

Dosage -

To treat bacterial infections 10g per 1200 Gallons/Add daily for 3 days

To treat parasite infections 20g per 1200 Gallons/Add daily for 4 days.

When to use?

When fish show symptoms of a bacterial infection (ulcers, fin, tail or mouth rot, loose scales),

parasitic infection (Costia, Trichodina, skin or gill flukes), flicking and rubbing against rough surfaces or gasping.

How to use?

Test your water quality.

Mix the appropriate dosage in a clean bucket of pond water and pour evenly over the surface of the pond.

Switch off UV filtration until 48 hours after adding the final dose. Aerate the pond well during treatment.

Add filter bacteria 48 hours after adding the final dose to boost the biological filtration of your pond.

If you feel a repeat dose is necessary, check your diagnosis, a different medication may be more suitable.

Allow 10 days after adding the final dose and perform a partial water change before re-treating or treating with a different medication.

Always treat when you have time to observe fish and take appropriate action in the unlikely event of a bad reaction.

Follow the safety information below throughout the course of treatment.

Warning:

Do not use with orfe, rudd, tench or sturgeon/sterlet.

Wear disposable vinyl or latex gloves and appropriate eye protection when handling this product.

Do not use if the pH is below 7, the carbonate hardness (KH) is below 6°dH and/or the general hardness

(GH) is below 6°dH. Do not use in bright sunlight or in hot, humid, thundery conditions.

Do not use if the water temperature is below 10°C.

Do not store in a hot place.

Do not mix medications.

It is important that you know your pond's volume. All treatments are based on the number of gallons in the pond. The wrong dosage could result in killing your fish.